PeteDotCom -> Networking -> Networking -> Dial Up Diagnostic ->   Connect Modems Start/Program/Hyperterminal Use command to Reset Modem         azt that will show                               Ok Use command to show Register settings at&v set test timer register (S18) to desired time ats18=9 check S18 register has been changed     at&v Run Local! Test between computer and modem at&t Type in a string a characters to test End Test and Reset Modem                 atz (* may have to type (+++)) Run Local Modem Test              ats18=12&8 wait 12 seconds for error display (it should display "000" if its is correct) Reset Modem                          atz Dial Second Computer for Remote Test atdt (number #) second computer may have answer   ata wait for connect signal second computer to give permission for test at&t4 ( just before the first computer type the next command) Fist computer to initiate test at&t6 type in a string of characters to test end teset type+++ Reset Modem Initiate Modem to Modem Test atz Wait 5 seconds for error display (if no errors it should display 000) Reset Modem atz Initiate loop back test at&t3