Once the epoxy has dried on the hinges, the ailerons and flaps can be connected.  The templates are used on the bottom to hold them in neutral until the pulleys are fitted.

The aileron pulley fitted to the rear spar of the wing.  It is set in place with clecos until it is ready to be glued and riveted.

The flap attached to the flap hinge.  The flap pulley is also being fitted in place and the rib has been notched to allow the cable through.

Here is the jury strut attach bracket.  The wings must be hung on the airplane to get the proper angle so that it meets with the jury strut.