TUTORIAL #9


Gloria


By: Maggie Santiago


1. Start about 1� inches from the end of the wire, turning the long piece up (see picture #1)

2. Grasp the wire (the longer piece) about � � above the bend . Bend the wire to the left, down and to the right to make a loop (picture #1)

3. Grasp the wire close to the loop and bend the wire up
. 4. Grasp the wire at the bottom of the bend (picture #2) and bend it to the back; pinch a little

5. Grasp the wire at the bottom of the �G� bend it to the left, go around the other leg of the �G� and bring the wire to the right, bend it down to make a loop (picture #3)

6. Grasp the wire and bring it up, grasp it even with the top of the �G� bend it to the left and down from the back of the wire; you have form an �L�
7. Grasp the wire even with the bottom of the �L� and bring it up
8. Grasp the wire about half way of the �L� and bend it to the right and down
9. Grasp the wire even with the bottom and bend it to the left, up and to the right halfway and down, hide the wire behind the �o� (picture # 4)
10. Grasp it from the inside of the �o� and bring it up
11. Grasp it even with the top of the �o� and bend it to the back, pinch it
(here you look at the picture below)
12. Grasp it were you just pinched it and bend to the right
13. Grasp the wire and bring it down, you have the �r�
14. Grasp at the bottom and bend it up
Note: Here you change pliers to the small round nose
15. Grasp the wire even with the top of the �r� and bend it to the right leave pliers there, and pinch it with the needle nose pliers to make the dot of the �i� pinch it to make it look like only one wire (picture # 5)

16. Grasp the wire and bring it up
17. Grasp the wire even with the �o� and bend it down
18. Grasp the wire even with the bottom of the �i� and bring it up and to the back
19. Grasp the wire from the inside of the �a� and bring it down hiding the wire in the back
20. Grasp the wire and bring it up
Congratulations you finish the name. Now, take the end; grasp it a little higher than the tip of the �D� (look at the picture for reference) and bend it up, fold it back and around the pliers twice, to form a double loop; then around the wire twice to finish it; cut the excess in the back. This is for the chain; do the same with the piece of wire that you left in the very beginning. Finish filing the ends and carefully crimp the ends. Polish it a little and Enjoy it!!!

LINKS TO THE LESSONS
Lesson one
Lesson two
Lesson three
Lesson four
Lesson five
Lesson six
Lesson seven
Lesson eight
Lesson nine
Back to Index
Here is where you will
find all the tutorial links

If you have a problem I will try to help. Email me at: Maggie

Please use these lessons for your personal use only. Do not include them in any lesson plans, in whole or part, that you are teaching or publish them on any web page or use them in any commercial way without permission from me.


These pages are all copyright 2001 by Maggie Santiago.

If you find something wrong with these pages please contact [email protected]
Hosted by www.Geocities.ws

1