 |
| OTHER |
| -----SUPER-CLAW-CONTROLLER----- --Powered By--RCX --Controlled By--Human hand --Piece Count--Unknown --Motor Count--0 --Status--Dissassembled --Notes--A super controller. This controller conbined three different home made sensor configurations to make one super controller. It was used to control a "battle claw" with a simple movement of your hand. Basicly if you move your hand the manipulator will move in the same manner. It makes controling manipulators extreamly easy. |
|
 |
 |
 |
| -----ETCHABOT----- --Powered By--RCX --Controlled By--RCX-code program --Piece Count--215 --Motor Count--2 --Status--Dissassembled --Notes--A drawing robot. It used preprogrammed commands to draw pictures. It used one motor to control the virticle lines and another for the horizontal lines. I had it programmed to draw a simple house with a door, chimney, and roof. I also programmed it to write my name. Each program drew a picture in several seconds. This is a whole lot easyier that trying to draw it yourself and if your not good at programming you can also use the an infared remote to give it direct commands. |
 |
 |
 |
| Click on anything below that you want to see and you will be brought to its page!!! -Manipulators- Mobile Manipulator 2-Joint Manipulator 5-Fingered Manipulator Battleclaws Battleclaws 2.0 -Boats- Boat-1 Boat-2 Half-Sub-Aquabot Turbo-Tri-Prop -Ambulators- 6-Legged Ambulator 8-Legged Ambulator Bipedal Ambulator Monoped-Stompbot -Wheels- Rollbot Razortooth -Tracks- Snow Rover Trackbot 1.0 Trackbot 2.0 -Other- Super Claw Controller Etchabot -Prototypes- Prototype Car Prototype Biped Prototype Manipulator Prototype Controller Prototype Photobot Prototype Scanner Prototype Wrist |
|
|