Interior
Before:
Here is what it looked like when we got it. Boy was this thing a mess. Note the
"cool" rice pedal pads. Those lasted about 14 seconds. My wife ripped
out the seat and did a damn fine job of rebuilding it. Cant's even tell
except for the occasional flash of duct tape.
Here it is with the seat out. Lots of rust in floor boards. We had some
stainless cut to size and pop riveted to the remaining good metal. This is going
to be a working truck so were going for tuff functionality, not show. If you
look close you can see where some bozo cut the transmission tunnel to clear the
shifter instead of just unbolting it.
Note the killer 10" hole in the door for a now absent speaker
After:
All new gauges, door kick plates, door seals, and carpet. Not a bad improvement
if I say so myself, and I do. Now at least I can drive around in the thing with
out feel too white trash.
7/2001 - The ultimate solution to our rusty floorboards. An entire new
cab!
Starting out the "new" cab right. A little Dynamat to keep the noise down and some
fresh paint. Putting the new cab on was a real pain in the ass. But with only a
few 2x4's the wife and I got it done.
| 
