Home
Product
Services
Tool Tips
About Us
Contact Us
Saftey Instructions
|
|
The tungsten carbide tipped circular saw blades are designed for many special applications and can be used to cut a variety of materials. They are manufactured with finest tungsten carbide tips and different tooth design for special use. All carbide tipped blades can be re-sharpened or re-tipped for longer sawing life. |
Operating Conditions
Machine cover is essential to minimize the injuries by flying broken blades.
Irrelevant people are not allowed in the work shop.
Flammables and explosives should be kept away from the work floor.
|
Safety Measures
Wear glasses when working, to prevent from injuries by broken blades.
Watch out for your ties and sleeves. Long hair should be kept inside the cap, and no gloves are allowed during operation.
|
Before Use
Ensure the machines are in good condition with no deformation and no spindle vibration, the spindle's running tolerance can h7.
Make sure appropriate saw blades are used.
|
Installation
Ensure the saw blade turns in the same direction as the spindle does. If not, accidents are likely to occur.
Choose the flange whose inner diameter is the same as that of the saw blade but the outer diameter is a little larger than 1/3 (for multi-rip saw blade is 1/2) of the saw blade. Ensure the flange is clean, not over worn, bent and distorted shape.
Check the tolerance between the saw blade and the spindle. Install the flange and fasten the screw.
Be sure no people stand in front of the machine when starting the machine. Do not feed, just to check whether there is a vibration, radial or axial run out.
Saw blade reprocessing such as bore trimming or re-boring, should be finished by the factory. Poor reprocessing would lead to poor quality and may cause injuries.
While installation, the saw blade should be 5-6 teeth higher than the board surface.
|
In Use
In operation wood materials should be properly fixed lest abnormal cutting occurs.
The operation must be stopped rightly once unusual nose and vibration occurs, if not, rough surface and tip-breaking many occur.
|
After Use
Saw blade should be re-sharpened because dull saw blades many affect cutting effect and lead to accidents.
Re-sharpening should be made by professional factories, not changing the original teeth angle degrees.
|
Have questions about
your woodworking tools?
Our experienced staff is ready to assist you with any inquiries
you may have. Feel free to call us at
New Tech Saw Services
K-103 Amar kalony, Main Rohtak Road, Nangloi, New Delhi 110041, India
Mobile: 09811430147, 09818221758,09350665447
Phone: +91-11-65420988,+91-11-65420989
E-mail:[email protected], [email protected]
Top of Page |
|
Home |
Product |
Services |
Safety |
About Us |
Contact Us Copyright � New Tech Saw Services, 2007. All rights reserved.
|