JACOB WEBER'S
REMOTE CONTROL APPRENTICE AIRPLANE PICTURES
MENUS
Click to see more information on The APPRENTICE at Tower Hobbies Website.
I own a Tower Hobbies Apprentice which is the best trainer for moving from the high wing trainers to the low wing models. This one uses an OS .46 SX engine with 4 S-148 servos to a FUTABA R-148DF 8channel Micro Receiver (same that I use on all my models). It is then controlled by a FUTABA 8UAFS Super series, 8 Channel programmable radio.
COMING SOON, SEE BLOWN UP VERSIONS OF EACH PICTURE.
Side View of fuselage. The window is removable for the receiver power switch and antenna exit port which is run to tail.
Radio Compartment View. Note the Tight, clean lines of equipment installation.
O.S. .46 SF ENGINE MOUNTED ON FRONT OF APPRENTICE
Top Fiew of engine, spinner adds speed and allows better starts with an electric starter
Right side, upside down view. Shows the simple control linkage.
Top View of wing. Simple foam wing design with an aluminum main spare. Covered with UltraCote brand, low heat covering.
Bottom View of wing. Silver band on left wing added for visual reference in flight.
More Pictures (coming soon)
PREVIOUS (Gliders)
NEXT (Piper Cub)
Copywrite 2000 by Jacob Weber. All information contained is reserved to their proper owners and/or copywrites. Not responsible for outside links.
All Rights Reserved. Created Feb 16, 2000
Last Revised May 8, 2000