Recipe # 37
Eric's 12-second 1679
1. | Owner | Eric Sorg |
2. | Email Address | [email protected] |
3. | Vehicle Type | 55 Manx clone |
4. | Displacement | 1679 |
5. | Crankcase | used line bored case |
6. | Crankshaft | Scat, 69 stroke CW, 8 doweled |
7. | Connecting Rods | stock VW |
8. | Pistons&Cylinders | thick wall 88 CIMA'S Forged |
9. | Piston Rings | stock CIMA |
10 | Camshaft | Scat C35 regrind |
11 | Cam gears | aluminum with rivet attached, cut .060 groove in center on lathe |
12 | Cam followers | Scat |
13 | Pushrods | Bugpack chromemoly, cut to length |
14 | Cylinder Heads | CB 044, dual spring, 40x35.5, stock port |
15 | Rockers | used Autocraft 1.25 |
16 | Spark Plugs | NGK |
17 | Exhaust | modified Scat buggy to fit turbo & O2 sensor |
18 | Compression Ratio | 7.3, run 93 octane on street with 7 pounds boost, at track 114 or 116 with 10 pounds boost |
19 | Fuel System | Garrett T03 turbo (used of a Daytona), Zenith 32 NDIZ |
20 | Fuel Pump | used Holley blue pump |
21 | Oil Pump | Bugpack filter pump, NAPA filter |
22 | Oil Sump | free Mr. Bug 1.5 quart |
23 | Oil Cooler | dog house cooler, Scat 36 horse fan shroud with factory flaps wired open |
24 | Ignition | points, Bosch blue coil, used Bosch wires |
25 | Distributor | stock OEM distributor with advance locked out |
26 | Flywheel | forged lightened 12lb. stock, 8 doweled |
27 | Pulley | Power Pulley, Auto Haus |
28 | Clutch | stock rigid |
29 | Pressure Plate | used Kennedy stage 1 |
30 | Transmission | 68 swing axle with 4:12 r&p, super beetle mainshaft, 1.48 third, 1.04 forth, threaded superdiff, bus nose cone, Berg solid mount, solid rear mount with roll cage incorporated into it |
31 | Wheels | Centerlines 15x3.5 and 15x6...soon to be ERCO's |
32 | Tires | used 135 Mich front, M/T Sportsman I G60-15's rear |
33 | Max. Horsepower | |
34 | Max. Torque | |
35 | 0-60mph Time | |
36 | 1/4 mile Time | 12.3 @ 102 |
37 | Engine Mileage | around 10,000 miles |
38 | Cost To Build | mostly used parts $3000 for whole car, around 600 in motor , it pays to do it yourself |
39 | Purpose | street, drag strip, weekender |
40 | Comments | this is my first turbo motor, I learned alot...like turbo's are the way to go if you want to go fast, and how to tune a carb :). I could have built a bigger motor, or used a different carb to go fast, but I like to be different can't you tell..... |