Recipe # 26
Eric's Honda Killer 2161
| 1. | Owner | Eric Bertrand, Paris |
| 2. | Email Address | [email protected] |
| 3. | Vehicle Type | beetle |
| 4. | Displacement | 2161 |
| 5. | Crankcase | new AS21 full flowed |
| 6. | Crankshaft | 84 bugpack forged wedgemated |
| 7. | Connecting Rods | H beam bugpack 5.5 |
| 8. | Pistons&Cylinders | 90.5 mahle |
| 9. | Piston Rings | Total seal 2nd |
| 10 | Camshaft | Engle FK89 |
| 11 | Cam gears | steel on steel straight cut magnum |
| 12 | Cam followers | Scat |
| 13 | Pushrods | scat chromoly |
| 14 | Cylinder Heads | 44*37.5 fully ported JC heads (street elim style) dual springs |
| 15 | Rockers | 1.4 scat |
| 16 | Spark Plugs | NGK BP6ES |
| 17 | Exhaust | 1 3/4 GBE header custom stainless steel muffler |
| 18 | Compression Ratio | 9.5 CR pump gas (europ std) |
| 19 | Fuel System | 48 IDAs |
| 20 | Fuel Pump | Facet silver |
| 21 | Oil Pump | shadeck modified |
| 22 | Oil Sump | GBE |
| 23 | Oil Cooler | T4 oil cooler modified aftermarket fan shroud |
| 24 | Ignition | MSD setup |
| 25 | Distributor | MSD |
| 26 | Flywheel | aftermarket |
| 27 | Pulley | GBE equalizer power size |
| 28 | Clutch | GBE |
| 29 | Pressure Plate | KEP stage1 |
| 30 | Transmission | carter gear box 3.78/2.21/1.48/1.04 |
| 31 | Wheels | 5.5*15 ritter |
| 32 | Tires | 205/70/15 BFGoodrich |
| 33 | Max. Horsepower | |
| 34 | Max. Torque | |
| 35 | 0-60mph Time | |
| 36 | 1/4 mile Time | 8.7s for 1/8 mile |
| 37 | Engine Mileage | very few |
| 38 | Cost To Build | aprox 9000$ |
| 39 | Purpose | week end/ strip |
| 40 | Comments | Engine perform well, not as fast as kids on roller blades but much faster than their brothers in Hondas...This race engine will be replaced by a more streetable 1776 for the street car. New race car will be build to handle the new 2332 engine power. |
