| Project 64 Page 6 |
 |
| The passenger quarter panel had some body filler in it, so instead of trying to guess if it was done right by the last guy, I took a wire wheel to it and got everything off of it so I could see what I was working with. After wheeling through over 1/8" thick filler, I found that it really wasn't needed. I popped out a few small dings, and really didn't see the need for all that filler. |
 |
 |
 |
| As for the Driver side, all I had to fill was the antenna hole. The rest of the panel was straight. Woo Hoo! |
 |
 |
| I finished getting rid of all the rust spots in the trunk, and sanded it all down to primer it. On the inside, I filled all the holes that the PO drilled in the dash (there was a second hole on the other side of the ignition the same size) that was filled, and all the holes in the underside filled. Can you see where the patch panel was seamed? Better not, I spent too much time on it! |
| Click for larger image |
| Click for larger image |
 |
| Here you can see I've started to fill in the custom key work that was on the roof. I sanded the entire roof down and then primered, then added spot putty to the lettering. In case you cant make it out, it says "I AM A PIECE OF S---", and above it is a larger 'F' word. With my luck, this will show through the bodywork in about 3 years. |
 |
 |
| I was able to pound through the passenger side pretty quickly. All that's left is the ding by the rear window. |
| . |