1. First melt a candle or two into a pan or a bowl.
2. Add either (not both) soap or oil. I find oil works the best.
3. Pour the wax out of the pan or bowl and into a container or mold you would like.
4. Leave the wax so it can set or aleast cool down.
5. When you think it has cooled down put it in the fridge (not freezer) for about 1 and a half hours or two to play it safe.
6. After that time or when you think it ready, take it out of the fridge and then carefully out of the container or mold.
7. Then go wax a curb!!!
When you melt the wax you can throw in a couple of wax crayons to colour it!!!
It may not work perfect so you will have to put some layers on the curb!!!
GOOD LUCK!!!
1. First of all you will need to know how to put the trucks together. Get the base and put the kingpin in the hole. (with the screw part facing up.) Then get the bottom plate and fit it on the largest bushing (rubber). Then put the axal on followed by the smaller bushing with the plate on top. Then put the bolt on and screw it down. (The further down you screw it the tighter your trucks will be). Now do the other truck the same.
2. Now get one wheel and put one bearing in side. Now turn the wheel over and and put in an inner (not always needed) follwed by another bearing. Now put that wheel on one part of a truck and tighten the bolt (but not too much). Do the same with all of the 4 wheels.
3. Now get the main bolts (there should be 4 nuts and 4 bolts) and put then down through your deck (griptape at the top). Only do 4 at a time because it makes it easier. Then look at the bottom of the deck and and put the risers on the board followed by a truck. MAKE SURE THAT THE BUSHINGS ARE FACING IN OTHER WISE THE TURNING WON'T WORK!!!
Then tighten the bolts so the truck is securely fastened. Do this with both trucks.
Now your ready to go skate!!!
Just remember if the deck isn't gripped then take it to your local skate shop to get it gripped. But don't put the trucks on if it isn't gripped!
GOOD LUCK!!!