Now, more than likely there will be oil on the valvecover so have an oil pan ready to set the cover in. It should now look something like this:
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| D16A6 Camshaft Install | ||||||||||||||||||||||||||
| I bought this cam from Jegs. It's the Crane Cam stage 2 cam for D16A6. The cost was $317.99. A little pricey for a cam i think. | ||||||||||||||||||||||||||
|
||||||||||||||||||||||||||
|
||||||||||||||||||||||||||
|
||||||||||||||||||||||||||
| RPM Range: 1,500-7,500 | Skunk2 Camgear with cam | |||||||||||||||||||||||||
| Ok, now that you've got the cam, I went out and started at it. First, i took off the 4 nuts on the valvecover followed by the little metal things below them. Then, carefully, I got a flathead screwdriver and started to break loose the valvecover from the head. Now, more than likely there will be oil on the valvecover so have an oil pan ready to set the cover in. It should now look something like this: |
||||||||||||||||||||||||||
|
||||||||||||||||||||||||||
|
||||||||||||||||||||||||||
| NEXT | ||||||||||||||||||||||||||
|
||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||