NCJeeper's Military Truck and Equipment
Greetings and thanks for visiting my FOR SALE page.
Stanfield, NC (near Charlotte)
[email protected]

UPDATED 5/4/05


Link to pics of some of my other Toys
1977 M151A2 w/ROPS
UNCUT, runs and drives. Click on photo above for more details and pics.
GENERAC 6500XL Generator
Rated 6500W continuous, 8125W surge, 1ph, 60Hz, 120V/54.2A, 240V/27.1A, plus a 12V output for battery charging or accessories. Receptacles, two 120V/20A, one 120V/30A, one 120/240V 30A. Industrial OHV engine with pressure lubrication and low oil shutdown. Electronic idle control during no load conditions. Includes all manuals, accessories, tune-up kit, and wheel kit. Purchased new in Jan 2000 for $1300. Used maybe 50 hours. Runs like new.
1992 M101A2 3/4 ton CARGO TRAILER
Late model, standard 8-lug wheels, surge brake, heavy frame, galvanized 6'x8' box. Good tires, good woodland camo paint, full set of racks and bows. Mechanically A1, couple of minor dents in box and couple extra bolt holes in floor, absolutely no rust, few dents in tailgate but functions fine. Super clean underneath. This one doesn't need restoration. Perfect companion for your CUCV or HUMVEE, or just haulin'. More pics available on request.
Very good condition. 1980's mfg. Good strong canvas. I had to repair one 12" handling tear near the peak, does not affect strength. Comes with everything required to erect, including poles, ropes, and stakes. Designed to be erected by two people in 20 minutes. I managed to set it up by myself with just a little help from the wife. It is currently set-up for your inspection.
I can also provide a new-in-crate fuel fired heater kit that will keep you toasty warm in the coldest weather for an additional $100.
These are skid mounted, diesel fuel fired, electric powered steam cleaner/pressure washers manufactured for the US military by Mi-T-M Corporation. They will produce 300 F steam at 200 gph that can really make quick work of removing years of accumulated grease and grime from vehicles and equipment. I have a similar unit that has proven to be indispensable. Two to choose from. They are currently untested, but appear to be complete and in good condition. Probably wouldn�t take much to get them running. I have rebuilt similar units and they don�t usually need much. Parts and manuals available from Mi-T-M. Here�s the specs:
- Model #HS-0404-US10, NSN 4940-00-186-0027
- 208 VAC / 50/60 Hz / Single Phase / 15 Amps (will work on 220V just fine).
- 4.0 gpm / 400 psi cold/hot mode, 3.35 gpm / 200 psi steam mode.
- Triplex ceramic plunger water pump.
- 25 gal fuel tank.
- 75� steam hose with wand.
- Works with pressurized water supply (garden hose) or tank.
They are mounted on � ton M116 (same as M101) trailer chassis. More pics available on request. Buy them with or without the trailers.
$250 cleaner only, $500 with trailer
Model QM-2-28002
NSN 4320-00-913-7131
New and unused in the original packaging. Overhauled (new hoses and rustproofing??) in 1985.
Includes gasoline engine driven pump, hoses, nozzles, storage cabinet, and auxilliary equipment.
Pump is a BARNES, self-priming, 1-1/2", 50gpm, 100' head. Engine is a WISCONSIN model MBKND, 4.5hp, gasoline, all cast iron, waterproof magneto ignition, oil bath air cleaner. The pump/motor assembly is mounted on a skid that nests in the top opening cabinet. Includes two dispensing nozzles, one suction and two discharge hoses with cam-lok fittings, a "stinger" for pumping in/out of drums, ground rods, fire extinguisher, and starter rope. I�m sure it would work just fine with water and/or many chemicals. Approx 500lbs, 40"L x 34"W x 23"H. More pics available on request.
All good take-outs
Transmission, $75
Transfer Case, $75
PTO, $50
Crank with rods, $75
I also have several motors that were stuck due to negligence by previous owners. I know, it pisses me off, too. All internal parts are in good condition, but the blocks will need to be bored. Most have been disassembled and the parts boxed up. I will sell complete motors or parts. Just let me know what you need.
M37 front & rear axles, complete, $75 ea
M1009 Blazer front & rear axles, $75 ea
Wrangler rear, D35, 4.10 gears, good take out $150
More to come.
Hosted by