Fiber glass 16"tube |
||||||||||||||||||||||||||||||||||||||
Ken lowther and Bill Pruit came over to make a 10" tube, Ken made a detailed page on how to make your own fiberglass tubes. Click here |
||||||||||||||||||||||||||||||||||||||
Build your own scope. Check out the ATM page Click here |
||||||||||||||||||||||||||||||||||||||
Home page | Check out Finishing Fiberglass |
|||||||||||||||||||||||||||||||||||||
The 14.5 internet scope | ||||||||||||||||||||||||||||||||||||||
If you require information on building a tube you can contact me at [email protected] | ||||||||||||||||||||||||||||||||||||||
This is the wood and pipe spinable mold and the first layer of polyproplene sheeting. The second layer is taped with mylar tape. |
||||||||||||||||||||||||||||||||||||||
Three layers of 1.5 oz fiberglass mat are applied using polyester resin, before and after each layer of glass. The surface is then rolled smooth as possable. Once the resin is cured in 1-3 hours you have a fiberglass tube. |
||||||||||||||||||||||||||||||||||||||
The tube is then filled with automotive type body filler, and tacked to remove the dust, before priming | ||||||||||||||||||||||||||||||||||||||
This is the first heavy prime with urathane sealing primer |
||||||||||||||||||||||||||||||||||||||
Home Page | ||||||||||||||||||||||||||||||||||||||
Finishing Fiberglass | ||||||||||||||||||||||||||||||||||||||
[email protected] | ||||||||||||||||||||||||||||||||||||||