| The following is an alteration done to one of my Reflexs. This is for informational purposes only. |
| Any modifications are done at your own risk. Check local laws for restrictions on some of these changes. |
| BRAKE LIGHT PULSATOR |
| PROBLEM: |
| Need to make brake lights more visable |
| SOLUTION: |
| Brake Light Pulsator ( PICTURE TLP01) |
| TOOLS / EQUIPMENT NEEDED: |
| Knife |
| Small screwdriver |
| Wire terminal Connectors ( 3 spade connectors ) |
| Wire terminal connector tool |
| Wire Ties |
| Electrical Tape |
| DIFFICULTY RATING: |
| Easy |
| 1. Open Seat 2. Remove the light cover from under the seat. ( Picture TLP02 ) 3. Gently pull wires toward opening. |
| 4. You may have to remove tab or tie to make slack in wires. You are looking for green wires with a yellow stripe this is the brake wire. 5. You need to remove or cut back the protective covering. ( PictureTLP03 ) 6. Cut the green wire with yellow stripe before the connector leaving room to work with wire 7. Add spade ends to the cut wires 8. Plug the wires into the Pulsator ( Picture TLP04 |
| 9. Test |
| 10. Replace protective covering 11. Wire tie wires back into place and tuck in hole 12. Replace cover 13. Close seat you are done. |
| This makes the brake lights more noticeable. |
| INSTRUCTION: |
 |
|
| Picture TLP01 |
 |
| Picture TLP02 |
| Picture TLP03 |
| Picture TLP04 |
| If you need a larger view of any of the pictures on these pages E-Mail me with the picture number and I will send it to you. |
| Part # 06PP065X at JCWHITNEY cost $19.98 |
 |
 |
 |
| I switched from this to the alternating lights which are in my opinion better CLICK HERE to see that install. |
| Since people have different tastes I thought I'd leave this one here. |