 |
 |
| Home I Roster I Links I Ring Plans I Title Histories I Gallery I Media I Events I Divisions I Fed History |
|
| 2004 mWf Copyright Chris C |
| Here are the plans we came up with to build the ring that we use. Itdidnt cost us anything(I had all the wood we needed). It would prolly cost about $25-$40. But use as much junk as ya got. |
| 1. Find a lot of wood. We used a stock pile of 2x4's. 2. Then we cut 8 pieces 5' long. And hooked 2 together to make 4 10' long side pieces. 3. Cut four 4x4posts to whatever length you want to make the corners for your ring. (Note: the length of the posts will be the heighth of your ring) 4. Screw the side pieces to the posts. You can put the posts into the ground, or build a small frame at the bottom to hold it steady. 5. If you aren't going to put the posts in the ground, use some scrap wood to brace the bottom of the posts so they wobble around. 6. Screw 2 10' long 1x4's across two sides of the top frame. Also, put a couple car tires here and there to give it bounce and support. 7. Next, cut some 1x4's 4' - 5' long, and screw 4-6 of them on only 2 opposing sides and the middle supports. 8. Lay thin plywood or cardbaord, like us, screw or staple it down. 9. Lay down the padding or matresses on the platform. We use 2 queen size matresses, 1 twin, and some old pillows to fill the left over square. 10. Paint a tarp with your fed logo on it, lay it over the ring and your done. We use small rope to tie the tarp down, weave it criss/cross through the holes and some screws or something, on the top frame rails. |
| Steps 1-10 |
|