| BMW Inspection I | ||||||||||||||||||
| Undercarriage | ||||||||||||||||||
| -Change oil and oil filter while engine is at operating temperature. -Check transmission for leaks. -Check rear axle for leaks. -Half shafts: Check for leaks at flexible boots. -Visually check fuel tank, lines and connections for leaks. -Check condition, positioning, and mounting of exhaust system. Examine for leaks. -Check power steering system for leaks. Check p/s fluid level; add fluid if necessary. -Check overall thickness of front and rear disc brake pads using special tool. If replacement is necessary: Examine brake disc surfaces. Clean brake pad contact points in calipers. Grease wheel centering hubs (allow wheels only). Check thickness of parking brake linings only when replacing rear pads. -Check front control arm bushings for wear. -Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage and joint disc. -Check brake and clutch system connections and lines for leaks, damage, and incorrect positioning. -Check parking brake actuation. Adjust if necessary. -Check all tire pressures (including spare). Correct if necessary. - Check condition of tires (outer surfaces [left/right], tread wear and pattern; in case of uneven tread wear readjust wheel alignment if requested. |
||||||||||||||||||
| Engine Compartment | ||||||||||||||||||
| -Read out diagnostic system. -Check engine cooling system/heater hose connections for leaks. Check coolant level and antifreeze protection level; add coolant if necessary. Note: coolant must be replaced every 4 years (time begins from vehicles's production date). -Check level of brake and clutch fluid in reservoir. Add fluid if required. -Replace brake fluid every 2 years (timing interval begins from vehicle's production date). -Check windshield washer fluid level and antifreeze protection. Fill up and /or correct if necessary. -Check air conditioner operation. -Replace microfilter (does not apply to M roadster or M coupe). Note: reduce replacement interval in dusty operating conditions. -Reset Service Indicator. |
||||||||||||||||||
| Body/Electrical Equipment | ||||||||||||||||||
| -Check battery state-of-charge, and charge if required. -Check lighting system, i.e., headlights, foglights, parking, back-up, license-plate, interior (including map reading lights), glove box, flishlight, illuminated make-up mirrors, luggage compartment lights. -Check instrument panel and dashboard illumination. -Check all warning/indicator lights, check control. -Check turn signals, hazard warning flashers, brake lights, horns headlight dimmer/flasher switch. -Check wipers and washer system(s); wiper blades, washer jet positions. -Check condition and function of safety belts. -Check central locking/double lock. -Check operation of all latches. -Check heater/air conditioner blower fan, rear window defogger. -Check rear view mirrors. -Visually examine the SRS airbag units for torn covers, obvious damage or attachment of decals, decorations or accessories. -Activate automatic roll-over protection system (if equipped) via diagnostic link. Note: First remove hardtop/lower top. |
||||||||||||||||||
| Final Inspection | ||||||||||||||||||
| Road test with check of brakes, suspension, steering, clutch/manual transmission or automatic transmission. | ||||||||||||||||||