|
| 75 Body Repair Scheme |
| Step 3. Wire Tees |
|
|
 |
| This Tee will be made in the following steps. |
 |
| Start with a piece of wire that is slightly thinner than coat hanger wire. You need a good size wire for this to work correctly. |
 |
| Bend a little 1/8" "L" in the end of the wire. |
 |
| Bend it further in to a hook shape. |
 |
 |
| Crimp the fold down flat as shown. Make sure everything is crimped flat in both directions. |
 |
 |
 |
 |
| Slide a pair of pliers up to the end of the bent wire. |
| Bend wire over pliers until you have this 45 degree angle. |
| Now grasp the wire as shown and bend it back over the pliers... |
| Until it looks like this. |
 |
| Crimp this bend down flat. |
 |
| Hold the Tee as shown. Turn it over and press it down from side to side on a hard flat surface. This will square it up. |
 |
| Again, This is what the finished tee looks like. Now go to the last page and finish this repair. |