Do you have adhesive window visors and you want them off because there cracked or broke? Or you want to install new ones but cant because you have old adhesive on there?

Well, I have adhesive window visors on my truck and one was missing when I bought it. It would have looked really cool if I would have had them both, but since I didnt I had to get the other off.

Step #1: Try and pull the visor off, if that doesnt work, slide a knife or a razorblade as close to the paint as you can get without chipping or slicing into the paint.

Step #2: After you get the visor(s) removed, take your knife or razor again and very carefully get as much adhesive as you can off of your vehicle whithout scratching, chipping, or wrecking your paint.

Step #3 Now you need to get some 3M Adhesive Remover (or another kind of adhesive remover) and apply it to a durable paper towel, I used TaskMate wipers, fold the paper towel 2 times to make a nice square and get it wet in the middle, then apply it to the adhesive, hold it on one spot and move it around on that spot alittle and I took my thumb and rubbed it off alittle at a time with my thumb, it gave me a really big blister but looked really good after. There might be an easier way to rub it off but it seemed easiest.

Heres A Before and After Pic. The Before Picture Was Taken After I Already Did The Necesary Shaving of The Adhesive. It Was Alot Worse Than That You Could Notice It While I Was Going Down The Road Before And The Other Side Was Way Worse And Looks Like This After Picture Now Too!