Les's 2B kit car
Home
Donor car
Diary
PROJECT 2B KIT CONTENTS
Pictures
One cornerless tubular space frame chassis manufactured from 38mm outside diameter x 2mm wall thickness mild steel. A 50mm o/d back braced roll over bar with seat belt anchorages is incorporated in the chassis. Pick up points for the steering rack, front and rear suspension and rear sub frame are integral parts of the chassis as are the engine mountings and steering support. The chassis is fully welded and sleeved internally at the joints. For safety, the chassis design has key members well ahead of the front suspension and well behind the occupants.
Steering and Suspension Components
Steering rack and shaft
Track rod ends (pair)
Front springs (pair)
Front shock absorbers (pair)
Phosphor bronze bush tubes (pair)
Two top swivels
Steering column support bracket
Lower spring seats
Steering column bush bracket
Shockabsorber bracket material

Mild Steel Precut and Folded Outer Panels
Two body sides
One rear panel
Two rear wing panels
Left and right hand louvred bonnet panels
Nose cone panels (pair) and filler panels
Servo mounting panel

Set of GRP Panels
Front nose cone
Front cycle wings (pair)
Rear wheel arches (pair)

Set of Mild Steel Inner Panels
Floor
Seat back panels                   Stainless Steel
Firewall panels                      available as
Feet panels                          optional extra !
Tunnel sides and top

Windscreen Components
Toughened glass windscreen(BS Kite marked)
Two piece aluminium frame
Sealing rubber
Windscreen pillars (pair)
Wiper blades

Exhaust Components
One complete twin tube exhaust system
Stainless steel exhaust heat protector
Light Set (E marked)
Chrome headlamp units (pair)
Sealed beam units (pair)
Front flasher lamps (pair) and bases
Number plate lamp
Rear combination lamps (pair)
Rear fog lamp
Side repeater lamps (pair)

Interior Components
Mountney 11" leather rimmed steering wheel
Mountney steering boss
Dashdoard panel with pre-cut apertures
Perspex for instruments
Cockpit carpet
Length of vinyl
Cockpit edge finishing material
Snap on edge trim
Tin of glue

Miscellaneous
Radiator
Universally jointed propshaft with grease nipples
Set of three metal brake pipes
Fuel cap
Demister vents
Cycle wing brackets
Stainless steel stone guards and beading
Set of bonnet catches
Bonnet catch safety rail
Bonnet corner strenghteners
Nose cone grille and badge
Dummy rear wing piping
Under floor strenghtener section
Handbrake angle
'P' clips
Spare wheel threaded rod
Tube of silicon sealer
General fastner pack
Pair of gloves
Instruction video (9 hours)
      TOTAL COST OF 'ORIGINAL' PROJECT 2B KIT (ABOVE) ONLY �1145 + VAT
IN ADDITION TO THE ABOVE PARTS, THE FOLLOWING ARE ALSO SUPPLIED IN THE �1835+VAT KIT
       Pair of rear springs and shock absorbers                              Four flexible brake pipes
       Three point Securon harnesses (SVA correct)                     Number plate lamp bracket
       Set of four, 5 spoke alloy wheels with nuts (as show car)  Pair of mirrors (SVA correct)
       Pair of top quality, GM sports seats made by Recaro        Reversing lamp
       Stainless steel exhaust silencer (replacement part)               Hand brake cable
       Stainless steel 4 into 1 performance exhaust manifold         Washer bottle and pump
Hosted by www.Geocities.ws

1