This page lists some of the sequences that can be used. If you don't understand what the FR position or FRT position are, here's a word of advice. These refer to one of the pieces of the cube. To find the FRT position, you would find the F face, then the R face. The side piece between them is in the FR position. If it was in the FRT position, you would find the corner piece centered between the F face, the R face, and the T face.
NOTE: One letter positions, such as the F position, will always we a center piece. Two letter positions are edge pieces, and three letter ones will always be corner pieces.
Sequence: R- B+ R+ B+ F+ B- F- B2 Description: Moves an edge piece from the FR position on the second layer to the FB position on the third.
Before
After
Sequence: F- T+ L+ T- Description: Rotates an edge piece in the FT position.
Before
After
Sequence: R- B+ R+ Description: Moves a corner cube from the third layer to the position directly above on the first.
Before
After
Sequence: R- B- R+ Description: Moves a corner cube from the first layer FRT position to the FRB position directly below on the third.
Before
After
Sequence: R- B2 R+ F+ B2 F- Description: Rotates a corner cube in the FRT position on the first layer.
Before
After
Sequence: B+ F+ B- F- B- R- B+ R+ Description: Moves an edge piece from the RB position to the FR position.
Before
After
Sequence: B- R- B+ R+ B+ F+ B- F- Description: Moves an edge piece from the FB position to the FR position.
Before
After
Sequence: R- B+ R+ B+ F+ R- F- B- Description: Drops an edge piece from the FR position to the FB position.
Before
After
Sequence: R- B+ R+ B+ F+ B- F- B+ R- B+ R+ B+ F+ B- F- Description: Rotates the edge piece in the FR position.
Before
After
Sequence: R- B- R+ F+ B+ F- R- B+ R+ B2 Description: Switches the cubes in the FBR and FBL positions.
Before
After
Sequence: R- B- R+ F+ B2 F- R- B+ R+ B- Description: Switches the cubes in the FBR and PBL positions.
Before
After
Sequence: R- B- R+ B- R- B2 R+ B2 Description: Rotates the corner cubes on the third layer, keeping them in the same position.
Before
After
Sequence: (L- R+) F+ (L+ R-) B2 (L- R+) F+ (L+ R-) Description: Revolves three of the edge pieces on the third layer to different positions.
Before
After
Sequence: (L- R+) F+ (L+ R-) B- (L- R+) F- (L+ R-) B- (L- R+) F2 (L+ R-) Description: Rotates the edge pieces on the third layer, keeping them in the same positions.
Before
After
Sequence: VC+ T+ VC+ T+ VC+ T2 VC- T+ VC- T+ VC- T2 Description: Rotates opposite edge pieces on the third layer, keeping both in the same positions.
Before
After
Sequence: (L- R+) F2 (L+ R-) B2 (L+ R+) F+ (L+ R-) B2 (L- R+) F2 (L+ R-) B- Description: Rotates the edge piece in the FMB position, keeping it in the FMB position.
