POWERFLOR USA, INC.

Part III - INSTALLATION

3.01 INSTALLATION

A. Qualification

1. Floor system and accessories to be installed by the manufacturer's Authorized Installing Dealer to maintain the integrity of the products and acceptable performance of the completed installation.

B. Inspection

1. Examine subfloor for unevenness, irregularities, and dampness that would affect the quality and execution of the work.

2. Do not proceed with installation until subfloor surfaces are clean, dry, and clear of other trades and ready to receive flooring system.

3. Inspect POWERFLOR components for damage prior to installation.

C. Preparation and Installation

1. The floor system to be prepared and installed in accordance with the floor systems manufacturer's instructions covering preparation, layout, alignment, and installation.

2. Installed floor system shall be level within plus or minus 0.125 inches in 10 feet, and plus or minus 0.10 inches over the entire area. Free of rocking panels.

3. Provide cutouts, ramps, and closure trim as indicated and as needed. Minimize the number of cut panels. Layout panels to avoid less than 1/2 panel units. Scribe to accurately fit trim pieces.

D. Adjust and Clean

1. Remove floor system installation debris as work progresses, maintaining area under finished floor in a clean condition.

2. The general contractor is to protect the finished floor system from damage and misuse.

All Technical Data is From POWERFLOR USA INC. in house Data!

---

General Specs | Products Specs | Test Data Specs | Home >

 Locate the Nearest Representative PowerFlor USA, Inc

Contact Powerflor USA