mopedman

                                        Indian Four Assembly Instructions

                                                          - - - Notice - - -

THe material Presented within this manual assumes the reader has a fundamental knowledge of mechanical proceders and a working knoledge of mopeds. Any attempts to assemble or repair models described herein without such knowledge, and the required special tools and parts, may assumes no liability for such an occurrence.

This manual is based on units in production at the time of publication shown below. However, the company reserves the right to make changes to models, procedures, and specifications at any time without prior notice.

American Moped associates requires that, without exeption, all retail customers receive mopeds that have been properly assembled and prepared for sale.

                                                 CARTON INSPECTION

1. Upon receipt of unit, immediatly check bill of lading against information posted on end of shipping carton. If a discrepancy is found, make a note on the bill of lading. Inspect unit in carton.

Note: If a discrepancy is noted, check manufacturer's statement of origin of invoice. If MSO in error , please advise Traffic Department immediatly.

2. Inspect carton for signs ofdamage. If damage is found, make note of same on shipper's bill of lading. DO NOT REMOVE MACHINE FROM CARTON IF SHIPPING DAMAGE IS NOTED.

3. If shipping damage is noted, immediately contact shipper advising him of receipt of damaged merchandise. Follow his procedure for claim.

4. If shipping carton is undamaged, sign shipper's bill of lading and open the carton as outllined below.

5. Frame serial number is located on plate attached to steereing head.

6. Engine serial number is stamped on lower left hand side of engine while sitting on moped.

                                                       UNCRATING

1. Caution! Do not use sharp cutting tools to open top of box. Open top flap first. Remove fender, engine covers, and accessory parts box.

2. With top of box open, cut end of boz where front forks are located, ( a case cutter or linoleum knice makes a good tool) being careful not to cut ture fork. Cut cord tying wheel to frame. Remove brake assembly from wheel. Wheel may now be removed from box.
Have a small box or standle capable of fitting under engine. By pulling at the top of front forks entire unic may now be slid out of the end or carton. Place engine on box or stand so that front forks are high enough off floor to mount front wheel and fender.

3. Now open accessory box which should contain"
              1 set of pedals - marked R and L
              1 mirror
              1 axle with lock nut
              1 set front directional lights
              1 set fender bolts

                               FRONT WHEEL ASSEMBL Y

1. Remove four bolts (14mm) and lock washers from fork legs and install front fender, but do not tighten bolts yet.

2. Insert front brake assembly into front wheel. Front brake cable shouuld be routed in front of fork to prevent binding. Now inser front wheel axle through the lower fender brace first, then through the fork to your left viewed while you are sitting in front of the fork to your left viewed whilee you are sitting in front of the moped. THis fork leg can be identified by a small tab welded to wich fits into a slot on the brake backing plate. Tap axle lightly with a plastic or rubber mallet untill the tup just starts to show through the other side of the hub. Now place speedo drive unit in position making sure two



            More info on the way as soon as I get to typing it, its a grueling proccess. If you would like a hard copy of this manuel contact me via email Dan@Dewald.com