Throwing knife
get a piece of cork about 10 cm in length and about 5 cm thick.
3 washers, 1 bigger than the other 2
a piece of thin steel plating about 2-3 mm thick and about 30 cm by 20cm
a pin used in holding together the cork and washers.
see pictures --------------------------->>
Stert cutting out the cork with a knife or something you can make any design you want but i suggest mine in the picture --->
after the cork handle is complete then mark out the blade into any design you want, but it must be atleast 20 cm from the handle which would make the total blade length about 30cm including where it goes into the handle, remember it must be quite heavy so it will fly well
see pictures -------->
and below
