throw2

Throwing knife (cont)

Step 3

drill out the cork so the blade can fit into the handle (note: make sure it is a tight fit)

Now once you have drilled the cork drill out a small hole at the bottun of the blade to put the pin through.

make sure when you put the pin it is a tight fit and holds the handle on tightly

NOTE: use a roll pin because these dont fall out

see pics for better understanding ------->

Finished throwing knife

This is what your throwing knife should look like if you followed my designs

Tip for better preformance increase the blade size because mine is too small but it still works well

Warning

The "throwing knife" instructions on this website is for informational purposes only and is very dangeroius so i will not be held responsable for the damages caused by this throwing knife or other homemade weapons listed on this site.

Home

Hosted by www.Geocities.ws