Recipe # 48
Mike's nasty 2276
| 1. | Owner | Mike Ressler |
| 2. | Email Address | [email protected] |
| 3. | Vehicle Type | '68 Beetle |
| 4. | Displacement | 2276 |
| 5. | Crankcase | VW case as41, full flow, Lifter bores re-bushed |
| 6. | Crankshaft | 82mm forged CB performance |
| 7. | Connecting Rods | 5.4 CB Performance race rods |
| 8. | Pistons&Cylinders | Cima/Mahle 94mm |
| 9. | Piston Rings | Stock |
| 10 | Camshaft | WebCam 86B - hard welded |
| 11 | Cam gears | Straight-cut - Dyna gear - steel on steel. |
| 12 | Cam followers | Scat lube-a lobe lifters w/ SLR Cams treatment |
| 13 | Pushrods | chromoly |
| 14 | Cylinder Heads | CB performance CNC 044's 42X37 - right out of the box |
| 15 | Rockers | Scat 1.4's |
| 16 | Spark Plugs | NGK |
| 17 | Exhaust | S&S 1-5/8 merged with 2-1/2 ceramic coated Dynomax. |
| 18 | Compression Ratio | 8.7:1 - 93 octane |
| 19 | Fuel System | Dual Weber 48 IDF's on CB performance Big Beef manifolds(match ported) |
| 20 | Fuel Pump | Electric CB Performance rotary fuel pump |
| 21 | Oil Pump | Berg 26mm |
| 22 | Oil Sump | Scat 1.5 |
| 23 | Oil Cooler | Doghouse and external MESA 48 plate with thermostat and fan |
| 24 | Ignition | Blue coil |
| 25 | Distributor | Mallory Unilite |
| 26 | Flywheel | CB Performance forged 12.5 lb |
| 27 | Pulley | Scat stock size |
| 28 | Clutch | Copperhead |
| 29 | Pressure Plate | Kennedy 1700 |
| 30 | Transmission | r&p 4.12, stock gears except for 1.48 3rd, super beetle main ,super diff, heavy duty side cover |
| 31 | Wheels | Stock chrome wheels |
| 32 | Tires | 165 front, 195/60 rear |
| 33 | Max. Horsepower | |
| 34 | Max. Torque | |
| 35 | 0-60mph Time | |
| 36 | 1/4 mile Time | |
| 37 | Engine Mileage | 100 miles |
| 38 | Cost To Build | approx $5,000-5,550 |
| 39 | Purpose | Weekender |
| 40 | Comments | Runs great all through the power band. Good low end, but really comes on about 3500-4000. Very torquey and sounds nasty. |
