Now for the tounge. We are going to make lines connecting that face we just extruded back to make polygons to exrude out which will be the tounge. See Figure 11.
Figure 11
Make sure all the edges connect at the vertices. Some might look like they do, but actually join at the vertex across from the one it looks like its joining. An example would be in Figure 12. There are only 2 edges selected when there should be 4. So what you do, is you delete those edges and draw in new ones. They should look exactly the same, except with 4 edges instead of 2.
Figure 12
Do the same for the middle vertical edge. (I found myself trying to fill in the edges to make faces, but since I didnt check for what I call long edges, I spent a long time trying to find out why the faces wouldnt fill.)
So what I did before finding out that I had a long edge, I filled in the two side faces as shown in Figure 13.
Figure 13
I finally corrected the problem and its shown in Figure 14.
Figure 14
Now fill the rest of the faces like in Figure 15.
Figure 15
