Ok, now make a new object. Make a vertically long square with the y axis set at two like Figure 1.
Figure 1
Now adjust the vertices in the back in the side view and move the tip of the nose face out a bit. It should look like Figure 2.
Figure 2
Now extrude the Tip_of_the_nose face merge the top two vertices together. You dont have to move them together, just set the merging value to 20 or something. It should look like Figure 3.
Figure 3
Now select all the vertices except the vertex in the middle on the right and rotate it with the right mouse button. Do it to both sides like Figure 4.
Figure 4
Select the edge in Figure 5 and delete it. Now select the Side_Of_the_nose_faces and delete them., now draw edges like Figure 6 and fill them.
Figure 5
Figure 6
Now select the two vertices shown in Figure 7 and go into the side view and move them back. Now draw edges from the top edge like in Figure 8 and fill them.
Figure 7
Figure 8
Do the same and fill the edges like in Figure 9.
Figure 9
Ditto like Figure 10.
Figure 10
