DIY Section
My own version of the JDM tilting plate holder project. (This was done during my Christmas vacation, 2006.)
The mighty tools for my DIY JDM tilting plate holder project.
The 2.5 inch wide by 2cm thick aluminum flat
bar sponsored by my friend Pio (thanks man!)
I used a steel saw to cut the aluminum bar into
two.
A closer look of the hand-sawn aluminum
flat bar.
The tilting plate holders after bending both
ends of the flat bars.
A closer look, needs some steel file and
sanding to smoothen the edges.
Drilling the holes for the mounting screws......
Testing, testing........
The finished project!!!
| Speaker Door Panels | Key and Alarm | JDM Plate Holder | Grill and Headlights |
Sound
Deadening