Kami memberikan solusi mudah untuk membuka/menutup pagar Rumah/Gedung anda
By KENT Automatic Gate
Copyright 2002-2013 KENT Automatic Gate & Press Door Hardware. All Rights Reserved.
Guide to Sliding Gate Installation
A sliding gate requires room for it to slide. The basic rule of thumb is it requires the width of the gate way plus 400mm extra to allow room for a gate operator and allowing for an overlap.
It is important that a sliding gate moves smoothly through its entire opening so good quality wheels with sealed ball bearings running on a straight metal track fixed to a concrete footing should be used. The bottom of the gate should not contact the track for the whole opening of the gate, if it does the automatic operator will NOT work properly. 65mm or 75mm Galvanised Steel Posts should be used either side of the driveway and behind the gate at the open end if a guide post is preferred.
DO NOT USE THREE WHEELS on a sliding gate as this may de-rail the gate. Two wheels will always bear the load evenly. If the gate is very heavy then use two larger heavier duty wheels and a heavier duty bottom rail.
If the ground drops off the edge of the driveway a galvanised steel rail can be used to support the gate track. This rail should be in line with the driveway so if the driveway slopes up a bit so should the steel rail.
JANGAN GUNAKAN TIGA BUAH RODA PAGAR !!!!!!!!!