 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
| Step 1 Supplies: 1 1/2 inch wide 6 inch long PVC 1 Screw Driver 1 File 1 Hot Glue Gun 1 Secret Shot 2 |
| Step 2 Unscrew the gun, then carefully lift the cover off of the gun and set aside. |
| Step 3 Remove the Plunger located inside the yellow tube. |
| Step 4 Put a screw into the overflow valve hole. |
| Step 5 Cover the top of the screw with hot glue. |
| Step 6 Put the PVC in a clamp. |
| Step 7 Shave the PVC at one end untill it will fit tightly into the barrel. |
| Step 8 This is what it should look like (Sorry for the bad picture) |
| Step 9 Reassemble the gun and put PVC into the barrel. |
 |