| HET-RC Yak! Info |
| Cermark Brushless 480 motor install. 2 #64 rubber bands hold the motor in place. I also CA'd rubber band strips to each mounting beam for "grip" |
| Motor install II. Note the thin balsa strip on top of mounting beam. This was used to provide negative motor incidence |
| Servo Installation: 2 Hi-Tech HS-55s for elevator and rudder control. Rudder control was a simple addition to this kit. |
| Canopy Installation: Holes were drilled in the fuselage and yellow nyrod was CA'd in place. [Again, #64 rubber band material could be used under the canopy, but not needed. I did not use it this time, and with the plane crashing twice, there is still no damage to the canopy] The canopy was then screwed in place. |
| These are a few images from my HET-RC Yak1. You can e-mail me if you have questions... The combination used for this Yak: Motor: Cermark Brushless 480 ESC: Castle Creations Phoenix 25 Battery: Thunder Power 3S 2100mAh Li-Po Prop: APC 8x3.8 SF |
 |
 |
 |
 |
| Video is approximately 3Mb |
 |
| My Yak after an overhaul, oops |