Optimus Prime
Matrix:  All Cardboard and Magic 8-Ball.  Before the detailing.
Matrix held in by velcro and magnets.  Lights up blue.
Chest door installed.
Before I whittled down the shoulder lights.  No wooden frame installed yet.
This palm holds the gun.  A velcro strip will be down the palm.
1st time in the suit.  Isn't sealed up yet.
Optimus Primed!  The chest was completed later, so I started the paint job first.
Different stages of gun assembly.  The bottom is the trigger controls.  The Lazer Challenge isn't installed yet.
2 Screwdriver motors operate the door mechanism.  A pulley system was used to reduce torque.
Matrix guts.  A pressure switch was also installed so that the light would turn off when the doors closed.
Before and after for the comm panel.  Used keyboard keys and broken switches for the buttons.  A LED lights the screen when the door opens.  The pic is a screenshot I cleaned up.
The one above and to the right are the control panel that operates the door open and close, the shoulder lights, and the back fan.  It's connected with a network cable.
Finished Comm Panel
Water-resistant chamber for ice.  The fan is housed below the ice bag.  The details in the upper sides are vents.
Empty Matrix chamber.  The furthest back is flush with my chest.  There are circuit boards from broken print servers for detailing.
Gun handle detail.  Trigger operates 2 switches, just light, and Lazer Challenge trigger.
Rear Detail  The midsection is separate from the chest to allow twisting movement.
Matrix Chamber Activated.
Optimus' first steps!
Chicks Dig Giant Robots (and my wife still loves me!)
With Doc Ock
Go Back
Hosted by www.Geocities.ws

1