|
|
 
|
Here is my mounting method for the PT6702 DC-DC regulator. I cut down the leg on the upper right to pick up the heat sink stand-off. The leg on the upper left was extended with a small piece of copper soldered on to the heat sink. This was drilled and bent to pick up the second mounting point. The lower left leg was cut down so it barely touches the memory socket. The lower right leg was removed completely.
This mounting method allows the shield and cover to be installed. The upper "lip" of on the shield has been flattened to give a 1/8" clearance between it and the regulator module. The dip switches are easily accessible through the memory door. The dip switch is bent up slightly so that the memory can still be removed.
|
|
Send mail to [email protected] with
questions or comments about this web site.
|
