:: COMMON PROBLEMS ::
You screwed up - ehh ???
In this guide I will try to help u resolve the most common problems, that could occure after flashing...
CONTACT SERVICE
Some data or checksums in the MCU,PPM
or EEPROM is corrupted.
Reflash the phone with the original or corrected backup
"Quick set FAID" with KNOK
"Reset user interface settings" using KNOK
Or use Nokia Tool v3.25 by Jordik
"Make All"
"Quick set FAID" with KNOK
"Reset Sp Locks" with KNOK
"MCC+MNC Open and User" with KNOK
NO SIGNAL
use Nokia
Tool v3.25 by Jordik
"Make All"
"Quick set FAID" with KNOK
"Reset Sp Locks" with KNOK
"MCC+MNC Open and User" with KNOK
BAD EMEI
"told u - don't mees with eeprom"
Upload virgin eeprom using Rolis Flasher (how to ? see bottom of page)
Change IMEI using Noktool 18
"Reset SP locks" using Eprom tools
"quick set FAID" with KNOK95 Phoenix
NO network (no LOG)
Faid needs to be updated.
"Quick set FAID" with KNOK
If error still occure Try reflashing phone...
Can't turn phone "ON"
MCU data might be corrupted.
Reflash the phone with the original or corrected backup.
Pictures and ringtones are fucked up.
Eeprom
registers needs to be updated...
Try to "Restore Full factory settings" using KNOK
Corrupt MSID after flashing
Your phone either was unlocked partially, or MCU or PPM is corrupted
Upload virgin eeprom using Rolis Flasher (how to ? see bottom of page)
Change IMEI with Noktool 18
"Reset SP locks" with Knok
"quick set FAID" with Knok
Phone "hangs" when trying to
use WAP(6210,3330)
Reset phone to "factory settings"
using KNOK
Blank screen
Could be caused by corrupted EEPROM
Reflash a Virgin eprom
Or Flash your backup to phone
If none of the above tips fixed your problem, try visiting forums