Extra Features of Nokia 6510

Auto Keyguard

Higher Screen Resolution

Wallet Feature

Get the 6510 MCU+PPM here: http://www.handy-flashpage.tk/

Get the 6510 LCD Screen from here: Diamondchoice

I'm assuming you know about FIA files as this guide is for ADVANCED individuals only!

:: WorkShop ::

Ensure your phone is Switched Off with no Sim card in!

Plug your flasher into your parallel port, plug the power cable into the USB port and connect your phone to the data cable.

Now run WinDCT4 (zip file containing 1 set of FIA) click here to download.

If all is well the program will auto detect your DCT4 flasher dongle.

First you must select the PPM pack you want to flash, the software will then automatically find the MCU file by itself. (as long as the MCU file is in the same folder as the PPM file).

FOR EXAMPLE

MCU filename: nhm75505.800

PPM filename: nhm75505.80c

As you can see the above filenames are very similar but it is easy to detect which one is the PPM pack

as it has an alphabetic letter on the end. In this example the PPM is pack "C". Pack C is normally the European language pack containg English, German, French, Italian, Turkey.........

Anway back to the flashing process. Press the button on the software to select the PPM file. Continuing with our example we will select the PPM file named nhm75505.80c.

The software will then load both the MCU and PPM automatically.

Now you are ready to press the magic flash button.

Press the flash button and when prompted to power on the phone, plug the charger in and KEEP it in!

If all is working well the program will start erasing the flash memory.

Once the erasing process has been completed the program will begin to write the MCU software.

To write the MCU will take about 5 minutes so sit back and watch the numbers tick by!!

Once the MCU has been written succesfully the phone will display the words: "Local mode" and the program will display a message box asking you to power off the phone.

What you have to do next is quite IMPORTANT! To turn the phone off it is best to remove the charger and disconnect the phone from the data cable and reconnect it again.

The words "Local mode" should NO LONGER be displayed on the handset.

In my experience for many 8310/6510's just disconecting and reconnecting the data cable is not always sufficient as the words "Local mode" remain displayed.

If this is the case simply remove the USB power cable for a second and plug it back in.

When you have succesfully turned the phone off (i.e local mode is not displayed) you must press ok button on the message box window.

The program will now ask you to power on the phone for a 2nd time.

Plug the charger in and keep it in and the program will begin writing the PPM pack.

The PPM pack will only take about one minute to write.

And thats it!! You have succesfully flashed your handset!

Now remove the 8310 original LCD screen with the use of a T6 Torx screwdriver and replace it with an original 6510 LCD Screen and power up your handset and enjoy your extra functions!

Internet Explorer 6 or above recommended and macromedia flash 6 plugin for best result

© 2001 - 2004 SmaRkieS Interactive

For comments and suggestions email to [email protected]