The 3315 Flash is actually a 3310 Flash. The only difference between the 3310 and 3315 is the eeprom. If you going to convert you 3310 into a 3315 follow these instructions for a 100% working conversion. Before you start, erase all of your voice tags. Not quite sure why, but if you are using 4 of your 8 voice tags, once you have done the conversion you only have space for 4 voice tags.  

Extra Features of Nokia 3315

Picture Message Editor with Clipart

Personal ringtones for your SMS alert

 Timed Profiles

Multiple SMS sending/erasing

 Automatic Keylock

Stopwatch

Get the 3315 MCU+PPM here: http://www.freegsm.biz

:: WorkShop ::

Ensure your phone is Switched Off with no Sim card in!

 Connect your phone to computer with flasher cable (LPT 1)

Read the Phone using Rolis478 and save it! - This is your Backup If something goes wrong you can always revert to your Backup!!

Load the MCU then Load the PPM files, Flash the 3310 to address 00200000 x 00400000 using Rolis478.

(When asked to power on phone, just plug in the charger for 1 second)

 When Flash is complete close Rolis and connect your phone to computer using an MBUS Data Cable.

 Now Switch on your phone

Run knok-phoenix build 1

Go to phone settings and click 'Quick Set Faid'.

Go to phone settings and click '3310 to 3315'.

 Go to phone settings and click 'Quick Set Faid'.

 Go to modify locks and click 'Reset SP Lock'.

 Go to phone settings and click 'Reset User Interface Settings'.

Close Knok Switch Off phone, disconnect cable, put sim in phone and put battery and back cover on then power up your 3315 ;o)

 If there are any problems like getting a signal follow the steps below:

 Try flashing this 3310 virgin eeprom to start address 003D0000.

 When Flash is complete close Rolis and connect your phone to computer using an MBUS Data Cable.

Now Switch on your phone

Run NokTool1.8 press Read Phone Info

Type in the box above the 'Change IMEI' button your original IMEI and tick the 'Change original IMEI' box.

Now press the 'Change IMEI' button followed by the 'Clear SP Locks' button then finally tick the box next to 'Update FAID' then press the 'Update FAID' button.

Run knok-phoenix build 1

Go to phone settings and click '3310 to 3315'.

 Go to phone settings and click 'Quick Set Faid'.

 Go to phone settings and click 'Reset User Interface Settings'.

 Close Knok, Switch Off phone, disconnect cable, put sim in phone and put battery and back cover on then power up once again...success?

 Now all you need is a 3315 conversion fascia and you have a 3315.

 If the virgin eeprom doesnt bring success or if there are any problems whatsoever, flash your backup (the original 2mb file you read from your phone).

Internet Explorer 6 or above recommended and macromedia flash 6 plugin for best result

© 2001 - 2004 SmaRkieS Interactive

For comments and suggestions email to [email protected]