 |
| Makeing A Spore Syringe:-----------[Psylocybe Fanaticus Meth] Materials list: 1. Spore print in jar. 2. Sterile syringe with water for injecting water into the spore print jar. 3. Sterile syringe for loading spore solution out of the jar. 4. A small Pyrex glass stirring rod (science - lab supply). 5. Alcohol, tequila shot glass and eye dropper. 6. Lid with two holes. Prepare this lid by drilling a hole in the center of the lid to fit the Pyrex glass stirring rod. Punch the second hole near the edge of the lid (rubberized edge up) to fit a syringe needle. Syringe preparation Boil a pot of water. Draw boiling water into a syringe and squirt it out several times. Refill the syringe with boiling water, replace the needle quard and wrap the syringe in tin foil. Prepare several syringes like this. Drop the syringes into the boiling water and boil them for one hour. Let them cool before using. The main point of this technique would be to expose the interior of the jar to as little room air as possible. Always protect the holes in the lid by placing tin foil or sterile surgical tape over the holes before and after this procedure. 1. Inject sterile water into the spore print jar through the needle hole. 2. Flame sterilize the glass stirring rod and let it cool a minute. Insert it through the center lid hole and with the rod end, scrape spores into the water. 3. Insert the sterile syringe needle through the small hole at the edge of the lid. Tilt the jar until the water comes up to the needle tip and draw the spore water into the sterile syringe. Store the syringe at cool temperatures in the dark. A properly prepared spore syringe will be good for several months and even up to a year or more. |
