LOGIN SETUP INSTRUCTIONS

After you intially unzip and install Pirch and go to run it for the first time there are a couple of simple *REQUIRED* steps you must preform before you may go online. Follows these instructions for trouble free LOGIN setup:

1) Open the program 

2) Select the LOGIN button. You will go to the SERVER CONNECTION box.The first time you run Pirch you will see several boxes with generic information entered. Edit this info as required.

3) IRC NETWORK:             Set new default network you would like THIS profile to start in. ( may be left as is for now )

4) SERVER:                       Set new default server you would like THIS profile to start in. ( may be left as is for now )

5) PASSWORD:                 You may elect to choose a PASSWORD in order to change settings ( not required )

6) PERSONAL INFORMATION: 
   (A)  NAME:               Fill in your name (may wish to use channel name)
   (B)  EMAIL:              Fill in complete email address

7 LOGON NICKNAME:
   (A)  NICKNAME:           First choice of channel nick you would like to use.
   (B)  ALTERNATE:          Secondary choice nick (sometimes needed)

INITIAL USER MODES:         Fill these 3 boxes in if desired. may be done later through /mode commands

AUTO CONNECT:               This handy little feature auto starts Pirch into operation.

***************************************************************************************
NAMING and SAVING PROFILE information

After you have filled in information boxes as required follow these steps to save your PROFILE

1) Select SAVE PROFILE      and follow these remaining steps

   (A)   SAVE PROFILE AS box will appear make sure the SAVE IN section contains the path in which you have Pirch. 
   (B)   FILENAME give it a name for this particular PROFILE.
   (C)   Select SAVE   (SAVE AS TYPE should say [PROFILES *.ini]

At this point you are back at SERVER CONNECTION if you select AUTO CONNECT it will have statred login for you. If not select CONNECT.


 