I reinstalled the Head
unit and attached the
CAS-VO5i ground wire to
one of the torx screws.
I routed all the wires through
the glove box and attached to
the PA11-VOL as per the USASpec
instructions.
I applied a sticky back piece of
Velcro to the bottom side of the
unit.
I applied the other piece of Velcro
to the back side of the glove box and
attached the PA11-VOL as shown. I
tied all the loose wires together
with a couple of zip ties.
At this point I tested everything,
just to be sure. All was working, so
I reinstalled the CCM and the pen
holder.