 |
| WaterProofing your servos |
 |
| This article will guide you through balloning you servos and could save you a bit of money in electronic stuff for your RC |
| You will need: Servos Balloons (regular round, any color)one for each servo 2 Zip-ties A Exacto knife or a sharp knife A small amount of grease rubber sevro gromets |
| Step 1 |
 |
| Take the servo off the RC car and take off all atachments(servo horns, ect...) clean it down and remove all dirt and water |
| Step 2 |
 |
| Strech the balloon over the servo making sure the servo leads are comeing out of the ballon hole. |
| Step 3 |
 |
| With the sharp knife cut slits in the ballons were the screws will go. Also cut a hole in the to for the servo shaft to patrude through. |
| Step 4 |
| Place a light coating of grease around the output shaft(arrowed) Install the rubber servo gromets if desired. and wrap a zip tie around the end of the ballon. |
 |
| Step 5 |
 |
| Repeat the above steps for both of your servos |
 |
 |
| Step 6 |
| Install the servos back into the car and re-center your servos and you can go off and drive with more confidence that the mud wont efect your electric's. |
|
 |
|
|
|
|
|
|
|
|
 |
