At this point, the heater box is complete, with the exception of the blower motor. My Dad is cleaning it up.

The dash assembly is complete. I need a new ash tray. If anyone happens to have an extra(any color), send me an email.

Here is the new a/c controller. The ends were soldered to the original, so I did the same with the new controller.

The original bulkhead connector was badly damaged. I found a new one on ebay. This was the only thing that was wrong with the original dash wiring harness.

I swapped wires to the new bulkhead connector one at a time. Some of the wires were completely missing, so I had to track them down using a wiring diagram in the service manual.

This is the start of the transmission reassembly. This picture shows the tailshaft, bearing and governer.

Here is a picture of the overrunning clutch/sprag.

All of the clutch, planetary sets, and bands in place…

Tailpanel all painted. I chose not to fix the small dent because I'd end up making it worse.