1, Notch out top corner of cooler just enough for the electric cord to pass with the lid on.
2, Wrap lead weights on the ends of the heater to keep it submerged.
(Be sure to set Heater in holding cradle so as not to come in contact with the Styrofoam. It will burn right through.)
3, Set clay pots upside down in the bottom as shown.
4, Install heater as shown.
5, Fill the inside with water just up to the tops of the clay pots.
(Optional) Drill holes in the side of the boxes toward the top.
6, Fill the plastic shoe boxes with Vermiculite as shown.
7, Place boxes inside the cooler.
8, Set thermometer on top of upper box.
Operation
1, Allow the water to come to room temperature.
2, Set heater so that it is �on� at room temperature.
3, Using the thermometer adjust the temperature for incubation.
(allow four to six hours to pass between adjustments.)
Tips;
Lift boxes out by using index finger and thumb at opposite corners.
Check temperature daily during incubation.
Open and inspect boxes at least once a week during incubation.
