Round Bottom     

 Garden Tractor Pullers

CLASS E 900LB STOCK ALTERED 0-10HP

CLASS F 950LB STOCK ALTERED 0-12HP

CLASS G 1000LB STOCK ALTERED 0-12HP

CLASS H 1050LB STOCK ALTERED 0-16HP

CLASS I 1100LB STOCK ALTERED 0-16HP

CLASS J 1100LB STOCK ALTERED 0-20HP

CLASS K 1150LB STOCK ALTERED 0-20HP

• MAXIMUM .030 OVERBORE ALL CLASSES

• STOCK STROKE ALL CLASSES NO STROKER KITS

• MAXIMUM VALVE SIZE 1.38

• VALVE LIFT MAXIMUM .330

• CARBURETOR 1" DIAMETER VENTURI MAX ALL CLASSES IT MUST BE ORIGINAL TYPE

• GASOLINE .750 GRAVITY ALL CLASSES

• LAWN MOWER TYPE GASOLINE ENGINES ONLY

• STOCK OR STEEL FLYWHEELS MUST BE COVERED 360 DEGREES WITH 1/8" STEEL OR 3/16" ALUMINUM

• PUMP GAS ONLY, NO PRESSURIZED TANKS OR NITROUS OXIDE, NO ALCOHOL, NO FUEL INJECTION, NO ELECTRIC FUEL PUMPS

• SINGLE CYLINDER FLAT HEAD ENGINES ONLY NO OVERHEAD VALVES

• 1200 LB CLASS IS A SINGLE OR TWIN CYLINDER CLASS AND OVERHEAD VALVES ARE PERMITTED ON TWINS

• NO RAM TUBES, OR HOMEMADE HEADS. HEAD PLATES AND TIE DOWNS ON HEADS ARE OPTIONAL.

• NO DIRECT THROTTLE LINKAGE TO CARB, MUST RUN THROUGH GOVERNOR ARM, ALL TRACTORS MUST HAVE WORKING AIR CLEANER ON CARB WITH ONE FILTER IN PLACE.

• NATURALLY ASPIRATED ENGINE, NO FORCED AIR OF ANY KIND.

TRACTOR REGULATIONS:

1. ALL CLUB MEMBERS MUST HAVE A TRACTOR NUMBER AND NUMBER DISPLAYED ON TRACTOR
2. MUST HAVE WORKABLE BRAKES
3. MUST HAVE WORKABLE REVERSE GEAR
4. MUST HAVE REAR FENDER, SHALL COVER FRONT PORTION OF TIRE AND TO CENTER LINE OF REAR AXLE
5. FACTORY SEAT OR EQUIVALENT
6. DEAD MAN THROTTLE IS MANDATORY ON ALL STOCK ALTERED CLASSES
7. ALL TRACTORS ARE TO HAVE STOCK APPEARANCE AND MUST HAVE HOOD AND GRILL
8. ANY PORTION OF TRACTOR IS NOT TO EXCEED 24" FROM CENTER OF REAR AXLE TO REAR END. NO PORTION OF FRONT OF TRACTOR, BOOM, OR WEIGHTS ARE TO EXCEED 7’ FROM CENTER OF REAR AXLE. WIDTH 10" FROM REAR TIRE TO A MAXIMUM OF 60" WIDE. BACK PORTION OF HITCH IS NOT TO EXCEED 18" FROM CENTER OF REAR AXLE. MAXIMUM WHEEL BASE 70" CENTER TO CENTER.
9. RUBBER TIRES ONLY (NO DUALS, STUDS, CHAINS OR STEEL WHEELS)
10. CUT TIRES ARE ALLOWED IN STOCK ALTERED CLASSES, 16hp AND UP.
11. MAXIMUM TIRE SIZE 26X12X12
12. IF EXHAUST IS MODIFIED IT MUST BE IN AN UPRIGHT POSITION AND PAST HOOD
13. TRACTORS MUST HAVE ALL SHIELDS AND GUARDS OVER CLUTCHES, DRIVE BELTS OR DRIVE TRAIN
14. ALL TRACTORS MUST HAVE A SAFETY DEVICE TO PREVENT TURNOVERS. THIS DEVICE IS TO HAVE WHEELS OR SKID PLATE. WHEELS ARE TO BE AT LEAST 1" WIDE SKID PLATES MUST BE AT LEAST 3X3" AT GROUND CONTACT POINT. WHEELS OR SKIDS MUST BE NO LESS THAN 5" BEHIND THE REAR TIRES AND NOT MORE THAN 5" ABOVE THE GROUND, IT MUST SUPPORT WEIGHT OF TRACTOR AND DRIVER.
15. HITCHES MUST BE RIGID AND HAVE 1 ½ " HOLE OR CLEVIS FOR HOOKUP, ½" MINIMUM TO ¾" MAXIMUM FROM BACK EDGE OF HOLE TO EDGE OF HITCH. HITCH HEIGHT MAXIMUM 12" ON DIRT 10" ON ASPHALT.
16. MUST HAVE HELMET IN STOCK ALTERED CLASSES MANDATORY
17. KILL SWITCHES ARE MANDATORY FOR ALL CLASSES
18. TWO WHEEL DRIVE TRACTORS ONLY
19. ALL ENGINES MUST HAVE A SCATTER SHIELD OPPOSITE THE CAM SIDE OF THE MOTOR. IT MUST BE MADE OF 1/8" STEEL OR 3/16" ALUMINUM. MUST COVER FULL HEIGHT AND WIDTH OF BLOCK AND BE ATTACHED IN A SECURE MANNER TO FRAME AND HEAD OR HEAD PLATE.
20. ALL FINAL DRIVE BELTS MUST BE COVERED TOP 180 DEGREES AND ALL CLUTCH ASSEMBLIES MUST BE COVERED 360 DEGREES WITH 1/8" STEEL OR 3/16" ALUMINUM.

** DEPENDING UPON TIME PERMITTED FOR EVENTS, THERE MAY BE A LIMIT TO THE NUMBER OF TRACTORS PER CLASS OR A LIMITED NUMBER OF CLASSES