 |
| Remember the left rear? She is looking better.....add alittle sheet metal and some elbow grease and you have a side to the Jeep. |
 |
 |
| This is the left rear behind the tire...I lost part of the cross member here. I will be replacing this as soon as possible.......>>>>>>>>>>>>>>>>>>> |
 |
 |
| The Drivers door was covered with serface rust that had pitted the sheet metal. I used maratic acid to eat the rust away leaving nice shiny steel. Then a very light coat of body filler, sand and prime. |
| The rear as you can see in the picture above and below has serface rust and a few bad holes. The rust will be treated in the same manner as the drivers door. As for the holes.....well, after I replace the rear crossmember I will either fabricate of purchase replacement sheet metal and repair the holes. |
 |
| Don't ever do this....a slight amputation in July cost me several weeks of work on the Jeep.......All better now, and I didn't lose the finger!!! |
 |
 |
To go to the Home page |
 |
 |
 |
 |
 |
 |
| Remember the floor? Well here is the after and a look back at before. Unfortunitly the passenger side has to be corrected also. But it is not as bad. |
|
|
|
| More pictures are on the way ......I just don't seem to find the time to work on the Jeep or here on the computer. Oh .....before I forget, I was told to let everyone know that the finger injury DID NOT occur while I was working on the Jeep......that was a FOREIGN CAR that bit me!!!! |
 |
| DONE |
| and the tailgate looks like new |
| OK...this part is in...2003 |
| SMOOTH |