|
Fuse Ignition Bomb
Directions:
A four strand homemade fuse is used for this. It burns like fury. It is held down and concealed by a strip of bent tin cut from a can. The exposed end of the fuse is dipped into the flare igniter. To use this one, you light the fuse and hold the fire bomb until the fuse has burned out of sight under the tin. Then throw it and when it breaks, the burning fuse will ignite the contents.
--------------------------------------------------------------------------------
Generic Bomb
Directions:
Aquire a glass container
Put in a few drops of gasoline
Cap the top
Now turn the container around to coat the inner surfaces and then evaporates
Add a few drops of potassium permanganate (<-Get this stuff from a snake bite kit)
The bomb is detonated by throwing aganist a solid object.
*AFTER THROWING THIS THING RUN LIKE HELL THIS THING PACKS ABOUT 1/2 STICK OF DYNAMITE*
Portable Grenade Launcher
Directions:
If you have a bow, this one is for you. Remove the ferrule from an aluminum arrow, and fill the arrow with black powder (I use grade FFFF, it burns easy)and then glue a shotshell primer into the hole left where the ferrule went. Next, glue a BB on the primer, and you are ready to go! Make sure no one is nearby.... Little shreds of aluminum go all over the place!! |
|
Big Boom Bomb
Materials:
- Oil based paint
- flare powder
-gasoline, karosene, or highly flammable liquid
-airisal can full
-gun powder
Directions:
Make a puddle with the oil based paint. Then pour the gas on the puddle. Then place the airisole can on the mixture, roll it around to get it covered then take the powdered flare and place it on the can. Then place the gun powder ontop of where you placed the flare powder. Light with a long fuse or a match. the gas/paint mixture will begin to burn, then the flare powder will ignite, acting as thurmite. This then will light the gun powder causing it to make a hole in the arisole can easier. Then hope you back far enough because it will launch paint chunks with flare powder at least 15ft away from the can.
--------------------------------------------------------------------------------
Blast Bomb
Materials:
- Arosol can, FULL!
- Ductape
- M-80, timed fuse
Directions:
1. Tape the M - 80 to the can with ductape
2. Light fuse and throw and run like hell.
3. the M-80 will blast the can to peices an the inside liquid will burn an burn things it lands on.
*TIP* More cans and more M-80 means bigger boom, Napalm anyone? |
|