Materials:
-9 Volt Lantern battery
-Piece of wood size of the pressure plate you want
-Four small pieces of wood approximately 1/4"
thickness
-A piece of flexible conductive material (sheet metal,cut coke can,etc.)
Directions:
1. Nail the four extra pieces of wood to the corners of the largest piece of wood.
2. Connect one wire to the positive lead of the battery
3. Nail the stripped end of the positive wire to the center of the large piece of wood.
4. Solder a second wire to the piece of metal
5. Dig a hole where you want the pressure plate. Place the piece of wood into the bottom of the hole. Set the metal on top of the four supports. Cover with a loose, thin layer of dirt, leaves, etc.
6. Attatch a third wire to the negative battery lead
--------------------------------------------------------------------------------
[ ] * Briefcase Bomb *
Materials:
-Briefcase
-Moustrap
-9 Volt battery
-Plastique
-Electrical blasting cap
Directions:
1. Remove all parts of the mousetrap except for the spring loaded lever
2. Attatch a wire to the positive lead of the battery and wrap it around the lever
3. Attatch a second wire to the negative lead to the battery to one end of the wire of the blasting cap
4. Attatch a second wire to the other end of the blasting cap wire
5. Put in a considerable amount of plastique into the briefcase
6. Insert blasting caps
7. Tape down the battery and mousetrap to the
bottom of the case
8. Push back lever and tape the final loose wire (leads to blasting cap) to the mousetrap so that if the lever would be released. It would complete the circuit
9. Keeping the lever held back in it's spring-loaded position, close the briefcase top and lock it
10. When it's opened, the lever will spring shut, completing the circuit to the blasting cap, igniting the plastique and blowing them to hell...
