Bullseye Quilts

 

For each bullseye block, cut:

1 – 10” square of tan fabric

1 – 8” circle of Fabric #1

1 – 6” circle of Fabric #2

1 – 4” circle of Fabric #3

 

Step 1)          To get the circles, you can take an 8 [6, 4]” square of fabric and fold in half, then in half again to make a small square.  Using a Ό circle template or free-handing it, cut an arc from corner to corner. 

 

 

 

 

 


DO NOT CUT OFF THE FOLDS!

 

Step 2)        Lay an 8” circle right-side up on the 10” square.  Sew around the edge of the circle about Ό” in from the edge. 

 

Step 3)        Turn the square over.  Pinch the square fabric and circle fabric so that you can pull the two apart from one another.  Clip into the tan fabric to make an opening for your scissors.  Cut out a circle (just cut the tan fabric) approximately Ό” inside seam that holds the circle onto the fabric.

 

 

 

 

 

 

 

 


Step 4)        Flip the block over and sew the 6” circle on top of the 8” circle.

Step 5)        From the back, pinch and cut out inside the stitching on the 6” circle.  Only cut out the fabric from the 8” circle.

Step 6)        From the front, sew the 4” circle on the 6” circle.  It is not necessary to cut out the back of the 4” circle.

 

Step 7)        Cut each block in quarters (they should be 5x5” !)

 

 

 

 

 

 

 


For the trading day

 

Step 1)          Make 15 whole blocks (or more) and cut them into quarters.

(9 people trading)

Step 2)        Offset-stack the quarters into sets of 7.  It would be nice if they were from different blocks.

Step 3)        Keep the remaining quarters (there should be 4) for yourself.

Step 4)        Bring the 8 stacks (56 quarters) in to trade.

Step 5)        Everyone will take one stack of 7 quarters from everyone else’s stack. 
Do not take one of your own stacks!

 

If you decide to make more than 15 whole blocks, still bring the 8 stacks.  If you want to trade the ‘extras’, keep them in a separate place until the initial trade is complete.

 

Size possibilities  

While it would be nice to believe that 10 inches is 10 inches is 10 inches, it would be a surprise if everyone’s blocks were all exactly the same size.  Keeping that in mind, expect to cut your quarters down to 4 ½”, just to get them all the same size.

That will create 4” finished blocks for your quilt. 

·        60 – 4” blocks with NO extra blocks (no plain ones) can be laid out in a 7 x 8 set, or 28x32” (that still only uses 56 blocks)

·        6x10 set – 24x40

 

Tracy's Home 


1 1