HOLDER A12 CULTITRAC DIESEL.
HORSEPOWER: Max. belt = 12.
MAX DRAWBAR PULL: 1,160Ib at 2,46 mph on 5.50 x 16 tires.
ENGINE: Type = Sachs, vertical air-cooled, 2-stroke diesel, 1 cylinder; Bore = 3.465
in., Stroke = 3.937 in., compression ratio = 20:1, rated speed = 2,000 rpm.
STANDARD TIRES: Front 5.00 x 16, Rear = 5.00 x 16,
four wheel drive and steering.
STANDARD SPEEDS: (with standard tires), Forward = 0.5 -1.2, 29, 3.5, 8.4mph,
Reverse = 0.5-1.2, 2.9 mph.
TURNING RADIUS; Approx. 6ft, ground clearance = 9-1/2in.
OVERALL DIMENSIONS: Height (to top of steering wheel) = 44 in, width = 28-1/2,
33, 36-1/2in., length = 80 in., wheelbase = 42-1/2in., track = 24, 28, 33 in.
WEIGHT; 1,500Ib with fuel, oil.
BELT PULLEY: Diameter 8-1/4in., width = 4-3/4in., speeds = 1,550rpm.
PTO: 1-5/8 in. spline shaft; 1,550, 920 rpm. Height above ground level with
standard tires = 19 41/64 in. End of shaft 17/32 in, ahead of drawbar pin. Shaft
central between wheels. Direction of rotation = clockwise, viewed from rear.
ELECTRICAL SYSTEM: 12 volts.
HYDRAULIC SYSTEM: Working pressure = 1,850 psi, pump capacity = 2.2 gpm (imp).
IMPLEMENT MOUNTING: 3-point linkage.
 |
|
|
Les Johnston's A12 |
|
 |
 |
Holder A12 Cultitrac Assembly and Disassembly Manual Cover (Thanks Les)
Manufactured
by: Gebruder Holder Maschinen Fabrik, Metzingen Wurtt, Germany