 |
| The Extention on the crankshaft bolt. |
| This is assuming that the tire is removed and the front driver side is on a jackstand. |
 |
| The tools that I used. Extention, Pull bar, and 19mm socket. All purchased at Pep Boys. |
 |
| Attatch pull bar to extention and angle it like in the picture, close to the front bumper. Then put all your weight on the farthest end of the bar and push down. The bolt should lossen and all should be good. Whatever you do DO NOT let go of the bar when you are putting your weight on it. The bar WILL snap back and hurt you very very bad. |
 |
| Removing the CrankShaft Bolt |
| Tools (size) compared to the stock rotors. extention is about one foot and the pull bar is about a foot and a half. |
|
| (INTEGRA) |